Air Duct Services

There's a point past which a duct system isn't worth cleaning or sealing — it's worth replacing. Sagging crushed flex, undersized runs choking the system, contaminated fiberglass liner that can't be cleaned, ductwork so leaky and so wrong that no amount of mastic will save it. Texas Service Experts re-ducts homes the right way: sized to Manual-D, built in durable materials, sealed and insulated correctly, and verified at the end. It's a craftsmanship job, and because the same whole-home crew also handles your registers, air quality, and the rest of the system, the new ductwork is built to work with everything else under your roof rather than in isolation.

Ducts fail for predictable reasons, and that's why patching eventually stops paying off: builder-grade flex sags, tears, and collapses over a decade or two; runs undersized from day one create high static pressure that shortens equipment life and leaves rooms uncomfortable no matter what you do at the thermostat; and fiberglass-lined duct that's grown mold can't be returned to a clean state — it has to come out. When you're sinking repair after repair into a system that's fundamentally wrong, replacement is the honest answer, and we'll tell you when you've reached it rather than sell another patch.

Our re-ductwork starts with design, not demolition. We measure the system — static pressure and, where it matters, a Manual-D right-sizing so the new runs actually match the equipment and the rooms. Then we build it properly: rigid round or spiral sheet-metal hard pipe where durability and low static loss matter, R-6/R-8 insulated flex where flexible runs make sense, fabricated sheet-metal or fiberglass-ductboard plenums, takeoffs and boots set and sealed, and the whole system strapped and supported to code spacing so nothing sags again. Every joint is sealed with mastic and UL-181 tape, every attic run insulated to stop loss and sweating. We can convert failing flex to hard pipe, add or relocate supply runs to condition a hot or cold room or an addition, and resize a mis-sized system to fix the airflow and noise problems no thermostat can.

The TSE finish is verification and documentation. We commission the new system — static-pressure and airflow checks, a Duct-Blaster leakage test to prove the new ductwork is tight — and document the build with photos before insulation and drywall hide it. You get a record of a system engineered and installed to a standard, not a pile of flex stapled into an attic. For a high-end home, that record matters at resale; for any home, it's the difference between comfort that lasts and a callback.

Full duct-system replacement and re-ductwork lives in this hub, along with flex-to-hard-pipe conversion, new supply-run and register additions for room add-ons, Manual-D right-sizing corrections, contaminated-liner removal and replacement, plenum-box fabrication and replacement, duct rerouting around remodels, and the duct insulation that finishes attic runs. It's the upgrade path for when cleaning (D1) and sealing (D2) can't fix a system that's simply at the end of its life.

Because it's one standards-driven crew, a re-ductwork job gets the same engineering and verification every time — and it's the same team that already knows your home's chimney, vents, and air quality. You're not hoping a separate installer knows Manual-D or owns a Duct-Blaster; you're getting the whole-home crew that earned its name on careful work. The value is the engineering and the proof: a duct system that performs the day it's commissioned, installed by people you'll see again for the rest of the house.

If your ducts are failing rather than just dirty, call (214) 444-8094 for an engineered re-ductwork assessment.